Development of repetitive current control for lead acid battery using arduino
This project focused on development of repetitive current control for lead acid battery using Arduino. The project uses Buck-Boost converter circuit with reference voltage of 14V from lead acid battery. The range of buck operation input voltage is between 18V to 15V while boost operation input...
| 第一著者: | |
|---|---|
| フォーマット: | Dissertation |
| 言語: | 英語 英語 英語 |
| 出版事項: |
2014
|
| 主題: | |
| オンライン･アクセス: | http://eprints.uthm.edu.my/1527/ |
| Abstract | Abstract here |
| 要約: | This project focused on development of repetitive current control for lead acid
battery using Arduino. The project uses Buck-Boost converter circuit with reference
voltage of 14V from lead acid battery. The range of buck operation input voltage is
between 18V to 15V while boost operation input voltage range is between 10V to 13V.
The current sensor uses in this project is to measure the output current with rating 50 A
versions and 40 mV/A output sensitivity. The results of simulation output current
slightly increase with the minimum value of 0.11A and the maximum value of 0.26A.
While the hardware output current is constant at1.71A for 10V to 18V. This project uses
MATLAB R2013b and Arduino UNO microcontroller with specification of ATmega328
processor. A repetitive current controller is been developed using MATLAB Simulink
Toolbox which communicates with Arduino Support Package library in order to
generate the pulse width modulation (PWM) signals.The project with the aid of
MATLAB software and Arduino is able to develop repetitive current control for lead
acid battery |
|---|